Triton RL5000, Service Manual

Page: 96 / 173

79
S
ECTION
3 - L
EVEL
II M
ODULE
R
EPLACEMENT
/ D
IAGNOSTIC
S
TATUS AND
T
ESTING
Section 3
9. Perform this step if a TVS module is installed, otherwise, go to step 10. Refer
to Figures 3-69 and 3-71. Remove the TVS module from the printer/transport
assembly support bracket by removing the brass standoff. Replace the brass
standoff to the secure the support bracket (with the attached ground wire)
to the printer assembly.
10. Refer to Figure 3-69. Remove the two (2) lower left/right mounting screws
that secure the printer/transport assembly support bracket to the con trol
panel.
11. Refer to Figure 3-69. Remove the two (2) mounting screws that secure the
presenter (and attached printer assembly) to the con trol panel.
12. Remove the printer/transport assembly from the control panel.
I
NSTALLING THE
P
RINTER
/T
RANSPORT
A
SSEMBLY
1. Refer to Figure 3-69. Mount the printer/transport assembly to the control
panel.
2. Perform this step if a TVS module was previously installed, otherwise, go to
step 3. Refer to Figures 3-69 and 3-71. Mount the TVS module to the support
bracket with the brass standoff (make sure the ground wire is still connected).
3. Refer to Figure 3-50 (XScale version) or Figure 3-51 (X2 version). Connect
the DC power and communication cables to the printer controller PCB.
Figure 3-68. Communication
and power connection for the
presenter
Presenter PCB
Presenter cable connection
Figure 3-69. Mounting locations
for the printer/transport assembly
and TVS module (if installed)
TVS Module (if installed)
Presenter