Triton RL5000, Service Manual

Page: 93 / 173

76
RL5000 S
ERIES
XS
CALE AND
X2 A
UTOMATED
T
ELLER
M
ACHINES
S
ERVICE
M
ANUAL
Section 3
8. Refer to Figure 3-63. Cut the tie wraps that bundle the wires from the print
mechanism and the cutter together along the bottom edge behind the printer
mechanism.
9. Refer to Figure 3-63. Disconnect the receipt paper autocutter cable from the
jumper cable. (The other side of the jumper cable connects to CN3 on the
printer controller PCB.)
10. Refer to Figures 3-64 and 3-65. Gently pull back on the black plastic pressure
clips at the front left and right corners of the cutter that help secure it to the
mounting bracket. Lift the front end of the cutter from the mounting bracket
and rotate it back on the plastic hinge ball snaps.
Figure 3-63. Location of the cable bun-
dle, the tie wraps, and the cutter motor
connection
Ground wire
connection
Cable bundle and tie
wraps
Cutter motor
connection
Figure 3-65. Location the cutter
mounting tray, pressure clips, and
snap hinges
Figure 3-64. Pressure clips that
secure the front end of the cutter
to the mounting tray
Pressure clips
Platen lever (blue) in
the closed position
Pressure clip
Hinge ball snap
Mounting tray