177
2.
Monitored ports number is not limited, but it can’t be the monitoring port
at the same time.
3.
Whether the monitoring port and monitored ports are in the same VLAN
or not is not demanded strictly.
4.
The monitoring port cannot be link-aggregation member.
Example
Create monitor session 1, then configure port 4, 5, 7 as monitored port and
enable ingress monitoring:
T1600G-52TS(config)# monitor session
1
source interface
gigabitEthernet
1/0/4-5,1/0/7 rx
Delete port 4 in monitor session 1 and its configuration:
T1600G-52TS(config)# no monitor session
1
source interface
gigabitEthernet
1/0/4 rx
21.3
show monitor session
Description
The
show monitor session
command is used to display the configuration of
port monitoring.
Syntax
show monitor session
[
session_num
]
Parameter
session_num
—— The monitor session number, can only be specified as 1. It
is optional.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the monitoring configuration of monitor session 1:
T1600G-52TS(config)# show monitor session
1
Summary of Contents for T1600-28TS
Page 1: ...CLI Reference Guide T1600G Series Switches REV2 0 0 1910011957...
Page 57: ...41 T1600G 52TS config show voice vlan switchport gigabitEthernet 1 0 2...
Page 64: ...48 Example Display the LACP system priority T1600G 52TS config show lacp sys id...
Page 365: ...349 Example Display the configuration of DHCP Relay T1600G 52TS config show ip dhcp relay...
