325
Chapter 33
SDM Template Commands
This chapter describes how to configure the Switch Database Management (SDM) templates to
allocate hardware resources on the switch for different uses.
33.1
sdm prefer
Description
The
sdm prefer
command is used to configure the SDM template. The SDM
template is used to allocate system resources to best support the features
being used in your application. To return to use the default template, please
use the
sdm prefer default
command. The template change will takes effect
after a reboot.
Syntax
sdm prefer
{ default | enterpriseV4 | enterpriseV6 }
Parameter
default
—— Specify the SDM template used in the switch as “default”.
enterpriseV4
—— Specify the SDM template used in the switch as
“enterpriseV4”.
enterpriseV6
—— Specify the SDM template used in the switch as
“enterpriseV6”.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Specify the SDM template as enterpriseV4:
T1600G-52TS(config)# sdm prefer
enterpriseV4
Summary of Contents for T1600-28TS
Page 1: ...CLI Reference Guide T1600G Series Switches REV2 0 0 1910011957...
Page 57: ...41 T1600G 52TS config show voice vlan switchport gigabitEthernet 1 0 2...
Page 64: ...48 Example Display the LACP system priority T1600G 52TS config show lacp sys id...
Page 365: ...349 Example Display the configuration of DHCP Relay T1600G 52TS config show ip dhcp relay...
