158
19.7
jumbo
Description
The
jumbo
command is used to allow the jumbo frame to pass through this
port. To disable this feature, please use
no jumbo
command. This feature is
disabled by default.
Syntax
jumbo
no jumbo
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Allow jumbo frame on port 1/0/3:
T1600G-52TS(config)#
interface gigabitEthernet
1/0/3
T1600G-52TS(config-if)# jumbo
19.8
speed
Description
The
speed
command is used to configure the Speed Mode for an Ethernet
port. To return to the default configuration, please use
no speed
command.
Syntax
speed
{ 10 | 100 | 1000 | auto }
no speed
Parameter
10 | 100 | 1000 | auto —— The speed mode of the Ethernet port. There are
four options: 10Mbps, 100Mbps, 1000Mbps and Auto negotiation mode
(default).
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Summary of Contents for T1600-28TS
Page 1: ...CLI Reference Guide T1600G Series Switches REV2 0 0 1910011957...
Page 57: ...41 T1600G 52TS config show voice vlan switchport gigabitEthernet 1 0 2...
Page 64: ...48 Example Display the LACP system priority T1600G 52TS config show lacp sys id...
Page 365: ...349 Example Display the configuration of DHCP Relay T1600G 52TS config show ip dhcp relay...
