TERRY HARMONY 2 Series, Installation Instructions Manual

Page: 60 / 106

Harmony Series 2 Homelift - XH00200 Issue: D Page 60 of 106
f) Confirm that the drive unit is adequately ventilated. Yes No
g) Confirm that the doors/ barriers/ ramps/ comply with the
relevant clauses. Yes No
Basic Safety System Checks
a) Lock Operation – Apply pressure to the door over full length of travel to ensure
it does not unlock
b) Emergency Release x 4 – Lift off the floor check key releases lock / Ensure
door pushes fully open / Ensure key does not jam / Check no operation of lift
c) Beak Secure – Check tightness of beak and bracket
d) Call Station Operation
1. Ensure all 3 call stations work correctly
2. Stop buttons
3. Remote on/off fob operation
e) Safe edges – For all safe edge checks the following MUST be checked.
Ensure that the lift Stops, Rides away from obstruction, Correct LED goes out
and No sticking edges.
F1 LH Car Top x 3 F2 RH Car Top x 3 F3 Door Top x 3
F4 Sling Top x 2 F5 Door Bottom x 2 F6 Underpan x 4
F7 Trap Door ( 4 up
and 4 down)
F8 Up Underpan S/Edge
x 2
f) Underpan safe edge override (9mm pad)
g) Trapdoor down safe edge override (20mm bar)
h) Door cable conditions – With the door actuator side panel removed, disconnect
the door connecting rod from the detent cassette and power the actuator motor
to the closed position. Close the door latch and send the lift up approximately
150mm and stop. Open and close the door manually ensuring that no LED’s
flicker, at the same time checking that there is no damage to the two multi-core
door cables.
i) Wall anchorages – Check tightness of wall / ceiling fixings at both levels
j) Battery backup – With lift at the top turn the mains off and check the lift
descends fully (turn on again after)