TERRY HARMONY 2 Series, Installation Instructions Manual

Page: 14 / 106

Harmony Series 2 Homelift - XH00200 Issue: D Page 14 of 106
Aperture Liner
The lift is supplied with an upper and lower steel aperture liner with tacfire boarding in
between. The liner is manufactured such that all sides are square and parallel to each other
and it is therefore important that it is not force-fitted in any way, otherwise this will affect the
clearance between the lift car and the aperture. The liner should be positioned as far back in
the aperture as possible, but leaving enough space for the tacfire board.
Refer to aperture liner INSTALLATION DIAGRAMS - FIGS. 2, 3 and 4
STAGE 1of 2 – Installation procedure FIG. 2 & 3
1. The lower frame must be pushed up into the lower aperture opening and be
positioned so the rear face is a maximum of 6mm (tacfire thickness) away from the
back trimmer and then secure in the sides with 1 screw on each side (Ref holes ‘A’).
(Do not fit all screws through the underside).
2. Prepare the upper level flooring for the top liner, by following the illustration below:-
Ensure all fixings within this area are
screwed down as firmly and tightly as
possible.
Please ensure that ONLY the carpet is underneath the
upper aperture liner (no underlay under the liner).