TERRY HARMONY 2 Series, Installation Instructions Manual

Page: 88 / 106

Harmony Series 2 Homelift - XH00200 Issue: D Page 88 of 106
Programming the Receivers
Receiver Unit Transmitter Units
Fob Wall Station
The receivers are programmed in the factory during assembly but if they need to be
reprogrammed proceed as follows
1) Resetting the Receiver
To reset a receiver so that no codes are contained within its memory, firstly remove the
cover. With power to the receiver, press and hold the X and Y buttons until both red LED’s
flash then extinguish.
2) Programming the ON/OFF Receiver
To program the ON/Off receiver, first remove the cover. With power to the ON/OFF
receiver, press the Y button 3 times until the yellow LED is ON. Whilst the yellow LED is
ON, press a button on the FOB and the receiver is now programmed. To check that the
receiver is correctly programmed, press button A on the fob and red LED 2 is lit. Press
button B and the LED goes OFF.
3) Programming the UP/DOWN Receiver
To program the UP/DOWN receiver, first remove the cover. To program UP, press the Y
button on the receiver and whilst it’s lit, press UP on one of the stations. All 3 LEDs will be
lit for a few seconds. Press the Y button again and press the UP on the second station.
Repeat the above for the 3
rd
station. All Ups are now programmed. To program the
DOWN buttons, press the X button on the receiver and whilst LED 1 is lit, press a DOWN on
a station. Repeat for all 3 stations using the DOWN buttons.