TERRY HARMONY 2 Series, Installation Instructions Manual

Page: 59 / 106

Harmony Series 2 Homelift - XH00200 Issue: D Page 59 of 106
Electrical Tests
a) Creep Control Voltage (8.1V)
V
b) Charger Voltage (13.7V) V
c) Control circuit full load voltage. V
d) Confirm that insulation resistance to earth exceeds 100 Meg
Ohms Yes No
e) Confirm that insulation resistance on safety circuits exceeds
100 Meg Ohms Yes No
f) Confirm that all metal work enclosing conductors including
the guides are bonded to earth. Yes No
g) Confirm that the car is earthed by a separate conductor. Yes No
h) What is the car ‘hold’ time delay?
i) Check that control circuit voltage does not fall below 11.5v
when lift is travelling down. V
j) Check all fuse ratings Yes No
Mechanical Tests
a) Confirm that the on-site load test has been successful Yes No
b) Confirm that the car clears all obstructions when driven at
rated speed. Yes No
c) Confirm that the lift car stops 12mm of the level
being served under all loading conditions Yes No
General
a) Confirm that a correct load plate is fitted in the car Yes No
b) Confirm that the door locks comply Yes No
c) Confirm that the circuit breaker (fuse) protecting the door
lock circuit will trip (blow) if the door lock circuit is earthed
(when tested at each landing and at the car door position). Yes No
d) Confirm that the manual emergency operation functions
correctly. Yes No
e) Confirm that the drive unit and drive mechanism have
adequate artificial lighting to conduct maintenance safely. Yes No