PRISM MPI2-25 and MPX2-25 Media Analysis Platform User Manual
50
NOTE.
The RTP Payload Type number must be unique for each IP stream.
The RTP Payload Type is displayed in the IP Status application.
d.
Set the Packet Read Schedule (PRS)
to
Gapped
,
Narrow Linear
, or
Wide Linear
to correctly measure the CMAX and VRX buffer
measurements in the IP graphs.
NOTE.
The PIT Histogram can be used to access the type of gapped, narrow
linear or wide linear stream.
e.
Set the TR Offset, which defines the timing reference offset of the sender
for network delays. Select Auto to provide an offset based on the current
video standard.
f.
Select the Gamma and Color Gamut
settings for the video stream.
See
Video IP input settings
for available Gamma and Gamut selections.
5.
To configure the Audio (2110-30)
stream tab:
a.
Slide the Enable Audio
slider to
Enabled
to begin configuration. (See
Figure 36
.)
Figure 36: Enable an ST2110-30 audio stream
b.
Enter the information in SFP Port, Source Addr, Source Port, Destination
Addr., and Destination Port for each audio stream.
c.
Set the
RTP Payload Type
between 96 and 127.
NOTE.
The RTP Payload Type number must be unique for each IP stream.
The RTP Payload Type is displayed in the IP Status application.
d.
Set the number of channels in the audio stream between 1 and 16.
NOTE.
The Bit Depth is already set to 24.
