PRISM MPI2-25 and MPX2-25 Media Analysis Platform User Manual
xvi
Use care when servicing with power on:
Dangerous voltages or currents may exist in this
product. Disconnect power, remove battery (if applicable), and disconnect test leads before
removing protective panels, soldering, or replacing components.
Verify safety after repair:
Always recheck ground continuity and mains dielectric strength
after performing a repair.
Terms in the Manual
These terms may appear in this manual:
WARNING. Warning statements identify conditions or practices that could result in injury or
loss of life.
CAUTION. Caution statements identify conditions or practices that could result in damage to
this product or other property.
Terms on the Product
These terms may appear on the product:
DANGER
indicates an injury hazard immediately accessible as you read the marking.
WARNING indicates an injury hazard not immediately accessible as you read the marking.
CAUTION
indicates a hazard to property including the product.
Symbols on the Product
When this symbol is marked on the product, be sure to consult the manual to find out the
nature of the potential hazards and any actions which have to be taken to avoid them. (This
symbol may also be used to refer the user to ratings in the manual.)
The following symbol(s) may appear on the product:
General Safety Product Specific Statements
Use the product only as specified. Review the following safety precautions to
avoid injury and prevent damage to this product or any products connected to it.
Carefully read all instructions. Retain these instructions for future reference.
Comply with local and national safety codes.
For correct and safe operation of the product, it is essential that you follow
generally accepted safety procedures in addition to the safety precautions specified
in this manual. The product is designed to be used by trained personnel only.
Only qualified personnel who are aware of the hazards involved should remove
the cover for repair, maintenance, or adjustment.
Before use, always check the product with a known source to be sure it is
operating correctly.
