Chapter 4. Troubleshooting and Diagnostics
EK–MOL80–SV. B01
4–11
Table 4–2 Operation Errors (
continued
)
Task
Problem/Symptom
What to do
Autochanger power fails
while a disk is in the drive.
If you need to remove the
disk before power can be
resupplied to the drive, the
eject tool can be used to
recover the disk. See the
instructions for using the
eject tool later in this
chapter.
Host computer power fails
and the autochanger
stays on.
After the host reboots, file
system check) any write-
mounted surfaces.
Both the host system and
autochanger power fail.
After the host reboots, file
system check any write-
mounted surfaces. See the
following CAUTION note.
CAUTION
Do not eject disks from the autochanger until all
mounted surfaces are unmounted.
Reading the control
panel display
window.
No display messages
appear.
•
Check that the power
cord is connected.
•
Check AC input.
•
Check the control
panel cable
connections.
•
Power cycle the
jukebox.
•
Replace the power
cable with a known
good one.
•
Replace the
autochanger
controller PCA.
•
Replace the power
supply.
