Chapter 5. Removal and Replacement
EK–MOL80–SV. B01
5–27
Reassembly
When replacing the translate frame, be sure that the frame is seated `flat' on
three positioning points at the bottom of the main frame, Two points are located
in front, left and right in front of the optical drives. One point is located at the
rear edge center area where the frame will rest.
When replacing the encoder strip be sure and thread the encoder strip end back
through the plastic slot and attach it securely to the retaining peg.
Also be sure the encoder strip passes through the sensor slot on the sensor PCA
mounted on the side of the picker frame. The strip may be moved off its mounting
peg while you are replacing the translate frame in the chassis.
Removing/Replacing the Encoder Strip
1.
Follow the steps in the service access procedure at the beginning of this
chapter to remove the right access panel, rear access panel and front right
panel.
2.
Release the encoder strip. Pull down on the encoder strip to remove the strip
from its retaining peg. Once released, the strip will slide up and out of the
plastic guide.
Figure 5–30 Retaining Peg On Lower End Of The Encoder Strip
3.
Remove the encoder strip anchor. Remove the T- 15 screw located on the
top front edge of the unit.
4.
Remove the encoder strip with the plastic anchor.
