StarLab GuardOne, User Manual

Page: 18 / 212

18 · GuardOne
®
· Manual
Installing the PC right sight panel (with cable duct)
1. Take the PC right side panel (with cable duct, no. 1b) and insert it
into the groove of the base plate. Make sure that the bottom holes
in the PC right side panel are aligned with the holes in the base
plate.
2. Make sure that the PC back panel slides fully into the groove of
the aluminium profile on the PC right side panel. Make sure that
the holes in the aluminium profile and the PC back panel are
aligned.
3. Use five of the plastic rivets (EVA01) to fix the PC back panel to
the aluminium profile of the right side panel. Push the rivets into
the aligned holes.
4. Use three of the plastic rivets (EVA02) to fix the PC right side
panel to the base plate. Push the rivets into the aligned holes.The
right side panel (with cable duct) is installed.
Installing the PC shelf to the back panel
1. Fix the PC shelf (no. 4) to the PC back panel using the two black
screw assemblies provided.
2. Position the PC shelf at the back panel on the inside of the PC
glass chamber of the GuardOne® Workstation.
3. NOTICE!
Property damage due to too high rotational
torques!
Turn the two black screws into the designated holes on the PC
shelf and the back panel by hand.
If necessary, you can provide additional support to the back
panel with one hand from the outside.
The PC shelf is installed at the back panel on the inside of the
glass chamber of the GuardOne® Workstation.
Fig. 7: Fix the right side panel to the base plate
Fig. 8: Fix the PC shelf to the back panel