Snapper RDLT Series, Operator'S Manual

Page: 25 / 240

Not for
Reproduction
Check Mower Blade Stopping Time
Mower blades and mower drive belt should come to a com-
pl4t4 stop w8t78n iv4 s42on3s 05t4r t74 4l42tr82 PTO sw8t27
8s turn43 of.
1. With tractor in neutral, PTO disengaged and operator in
seat, start the engine.
2. Engage the PTO and wait several seconds. Disengage
the PTO.
. î5 mow4r 3r8v4 14lt 3o4s not stop w8t78n iv4 s42on3s,
see an authorized dealer.
Cleaning the Battery and Cables
1. Pull seat up to access the battery and cables.
2. Remove screws ( A , Figure 10) and battery hold down
( B ).
3. Slide the battery (
C
) forward inside the battery con-
tainer (
D
).
4. Remove hardware ( E ) then disconnect negative cable
( F ) from battery.
5. Remove hardware ( G ) then disconnect positive cable
( H ) from battery.
. R4mov4 10tt4ry 0n3 pl024 on 0 l0t sur5024.
7. Clean battery container with a solution of baking soda
and water.
8. Clean the battery terminals and cable ends with a wire
brush and battery terminal cleaner.
Changing the Oil
Used oil is a hazardous waste product and must be dis-
posed of properly. Do not discard with household waste.
Check with your local authorities, service center, or dealer
for safe disposal/recycling facilities.
25
en
Remove Oil
. W8t7 4n68n4 of 1ut st8ll w0rm, 38s2onn42t t74 sp0rk
plug wire (
D
, Figure 4) and keep it away from the
spark plug.
2. Remove the dipstick ( A ).
3. Remove the oil drain cap as shown in Figure 11. Drain
the oil into an approved container.
4. After the oil has drained, install the oil drain cap.
Battery Maintenance
WARNING
When removing or installing battery cables,
disconnect the negative cable FIRST and
reconnect it LAST. If not done in this order, the
positive terminal can be shorted to the frame by
a tool.
WARNING
Battery posts, terminals, and related accessories
contain lead and lead compounds - chemicals known to
the State of California to cause cancer, birth defects, or
other reproductive harm. Wash hands after handling.
A dead battery or one too weak to start the engine may
be the result of a defect in the charging system or other
electrical component. If there is any doubt about the cause
of the problem, see your dealer. If you need to replace the
battery, see the
Cleaning the Battery and Cables
section.
To charge the battery, follow the instructions provided by
the battery charger manufacturer as well as all warnings
included in the
Operator Safety
section of this manual.
Charge the battery until fully charged. Do not charge at a
rate higher than 10 amps.
If you need to replace the battery, see Steps 1-6 and 9-11 in
the
Cleaning the Battery and Cables
section.
WARNING
K44p op4n l0m4s 0n3 sp0rks 0w0y 5rom t74 10t
-
tery; the gasses coming from it are highly explo-
sive. Ventilate the battery well during charging.
Charging the Battery
. R40tt027 t74 10tt4ry 201l4s, pos8t8v4 201l4 irst, t74n
the negative cable using hardware.
10. Place battery inside battery container. Secure with hold
down and screws.
11. Push seat down.