Form No. 3374-361
-ASM
Rev A
53cm Recycler
®
Lawn Mower
Model No. 20990—Serial No. 313000001 and Up
Operator's Manual
Introduction
This rotary-blade, walk-behind lawn mower is intended
to be used by residential homeowners. It is designed
primarily for cutting grass on well-maintained lawns
on residential properties. It is not designed for cutting
brush or for agricultural uses.
Read this information carefully to learn how to operate and
maintain your machine properly and to avoid injury and
equipment damage. You are responsible for operating the
machine properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your machine ready. Figure 1 identifies the location of the
model and serial numbers on the product.
Figure 1
1.
Model and serial number location
Write the product model and serial numbers in the following
space:
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol (Figure 2),
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
Figure 2
1.
Safety alert symbol
This manual uses 2 words to highlight information.
Important
calls attention to special mechanical information
and
Note
emphasizes general information worthy of special
attention.
Safety
Read and understand the contents of this manual before
you start the engine.
The safety alert symbol (Figure 2) is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
Improperly using or maintaining this machine could result in
injury or death. To reduce this potential, comply with the
following safety instructions.
The following instructions have been adapted from the
ANSI/OPEI standard B71.1-2003.
This cutting machine is capable of amputating hands
and feet and of throwing objects. Failure to observe
the following safety instructions could result in serious
injury or death.
General Operation
•
Read, understand, and follow all instructions on the
machine and in the manual(s) before starting.
•
Do not put hands or feet near or under the machine.
Keep clear of the discharge opening at all times.
•
Only allow responsible adults who are familiar with the
instructions to operate the machine.
•
Clear the area of objects such as rocks, wire, toys, etc.,
which could be thrown by the blades. Stay behind the
handle when the engine is running.
•
Be sure that the area is clear of bystanders before
operating. Stop the machine if anyone enters the area.
•
Do not operate the machine barefooted or while wearing
sandals. Always wear substantial footwear.
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3374-361
-ASM
* A
Summary of Contents for Recycler 20990
Page 18: ...Notes 18 ...
