45
Operating Instructions
Shift Inspection of the PC094
The PC094 should be inspected prior to every shift to ensure safe operation and
consistent performance:
•
Check the Hook Safety Latch for functionality.
•
Inspect the boom structure, turret, stabilizers and carrier for any defects
including
“
minor
”
dents, unusual material wear and breaks.
•
Inspect the wire rope for kinks, crushing, breakage, bird caging or other
abnormal wear.
•
Check electrical connections for damage or corrosion.
•
Check joints and rubber hydraulic hoses for leaks, wear, cracks and other
damage.
•
Check the Auto
-
Forward Switch on the tiller by driving slowly in reverse and
then pressing the button. The PC094 should immediately stop and begin
traveling forward.
•
Check the holding valve the prevents boom descent:
1.
Apply a load to the crane that is within the Rated Load Chart.
2.
Raise the load approximately 6 inches off the ground.
3.
The load should remain suspended for 3 full minutes.
4.
Lower the load.
If any deficiencies are found, DO NOT USE THE CRANE until the crane has been fixed.
Contact Smiley Lifting Solutions Service Department for assistance.
Smiley Lifting Solutions
5326 West Mohave Street
Phoenix, AZ 85043
Phone: 800
-
452
-
5011
Email: [email protected]
Web: www.smileyliftingsolutions.com OR www.spydercrane.com
Summary of Contents for SPYDERCRANE PC094
