Operation and Maintenance Manual (DTR) iSWAY
®
Set of products
Version 1.8 of 2.2021
118
The actuator is controlled by means of power supply polarity.
The appropriate voltage control
polarity for the component is determined during the start-up of the device, previously connected
according to the electrical design of the device
.
The canopy does not signal the end positions
(closing, opening). After starting the device, if the canopy does not open due to a malfunction, the
iSWAY-FC device still has a limited performance algorithm.
The actuator is powered and controled by 24VDC.
On request IP65 protection class can be delivered.
NOTE!
If an actuator malfunction is detected, inform the SMAY service immediately. Do not repair or
replace the actuator yourself. This can only be done by SMAY service or an authorised SMAY
service.
14.14.
Heating of SzA-FCK Automatic Control Cabinet
The SzA-FCK automation cabinet can be installed both inside the building and outside.
When mounted outdoors, the SzA-FCK automation cabinet is equipped with a heating system. The
thermostat KTO 011 manufactured by STEGO activates the SHT100 heater by Alfa Electric when
the temperature in the automation cabinet falls below the value set on the thermostat.
Fig.14.22. KTO011 thermostat (left) and SHT100 heater (right).
