3-30
(9) Media setting mode
Detection of the media edge when replacing or setting the media,
and selection of whether the media should be returned to the waiting
position are set.
When the take-up unit is in operation, the media will not be returned
to the waiting position regardless of this setting.
<Parameter (Enter a choice)>
-
NORMAL: Detects the media width when the media is replaced
or set, and then completes the media setting after
checking media skew at the end of media feeding.
-
SAVING:
Detects the media width when the media is replaced
or set and then completes the media setting after
detecting the edge of the media at the end of media
rewinding.
Usually set "NORMAL". When "SAVING" is selected, use
caution regarding the following points:
- Trim the edge of the media so that it is parallel to the guide
line and set the media to the printer.
If the edge of the media is not parallel, the print at the top is
missed, the platen is stained by ink and a paper jam is
caused.
- Set the media after checking that there is no wrinkle on the
edge of the media.
Using media with wrinkles can cause a paper jam.
- Set the media after checking that there is no tape or glue
attached to the edge of the media. Using media with tape
or glue can cause a paper jam.
#PAPER SET MODE
>01 : NORMAL
NOTES
Summary of Contents for IP-6900
Page 4: ......
