4-21
Section 4
Special Printing
HINT
1
Set the media.
For the installation of media, see
page 2-12 to 2-20 "Installing/
Removing the Media."
At this time, select "FACE" with the
or
key on the opera-
tion panel for "Media Position."
- If a tarpaulin (surface condition is different between face and
back) intended for single side printing is used, first print on
the more uneven surface side as the face side.
- If printing on thick tarpaulin (0.5 mm or thicker), the head
height must be raised. (
⇒
See page 2-66)
2
Set media in the winding unit.
For setting the media in the winding unit, see
page 2-27 to 2-32
"Installing the Media Roll in the Winder."
3
Make a mark for media positioning.
Make a mark for aligning the face side and
back side at the position where both edges of
the media come to the platen groove.
-
Making marks on both edges of the back side will be con-
venient when setting the back side.
MEDIA POSITION
SELECT: FACE
NOTE
Double-Sided Printing
Summary of Contents for IP-6900
Page 4: ......
