4-13
Section 4
Special Printing
2
Set media to the take-up unit.
For setting the media to the take-up unit, see
pages 2-27 to 2-33
"Installing the Media Roll in the Winder."
3
Start the printing on the face side.
4
After the printing is finished, cut the media.
When the printing on the face side is completed, two more lines are
printed. The first line is a solid line for aligning the print position
between face and back, and the second line is a broken line for a
cutting guideline.
Cut the media on the feed side, leaving two lines.
-
Marking the first solid line for aligning the print position
on both edges of the back side will be convenient when
setting the back side.
- The drying time of the printed side varies depending on the
image. Confirm that the printed side has dried before per-
forming the next operation.
In general, dry the printed side for more than 3 hours (a whole
day and night in case of printing with dark density), and then
print on the back side.
- Wind up the liner set on the sub scroller and secure the top
edge of the liner to the roll with tape. Printing on the back
side with the top edge of the liner hanging causes false de-
tection by the sensor, resulting in malfunction.
HINT
Broken line for a cutting
guideline
Solid line for aligning
the back side position
NOTES
Double-Sided Printing
Summary of Contents for IP-6900
Page 4: ......
