Savch S3100A Series, User Manual

Page: 99 / 157

95
Setting value Funtion Pulse or analog output 0.0%~100.0% corresponding function
11 Count value 0 to maximum count value
12 Communication setting 0.0%
～
100.0%
13 Motor rotation speed
0 ～ The rotation speed corresponding to maximum output
frequency
14 Output current 0.0A~1000.0A
15 BUS voltage 0.0V~1000.0V
06-09
DFM (P) output maximum frequency

Factory setting 50.00kHz
Setting range 0.01kHz
～
100.00kHz
When the DFM terminal is selected as the pulse output, this parameter is used to select the maximum frequency
value of the output pulse.
06-10
AFM zero offset coefficient

Factory setting 0.0%
Setting range -100.0% ～
+100.0%
06-11 AFM gain

Factory setting 1.00
Setting range -10.00
～
+10.00
06-12 AFM2 zero offset coefficient
Factory setting 0.0%
Setting range
-100.0%
～
+100.0%
06-13 AFM2 gain
Factory setting 1.00
Setting range
-10.00
～
+10.00
The above parameters are generally used to correct the zero drift of the analog output and the deviation of the
output amplitude. It can also be used to customize the desired AFM output curve.
If the zero offset is represented by "b", the gain is represented by k, the actual output is represented by Y, and the
standard output is represented by X, then the actual output is:
Y=kX+b. Among them, the zero deviation coefficient of AFM 100% corresponds to 10V, the standard output refers
to the amount of 0V ~ 10V corresponding to the analog output without zero deviation and gain correction.
06-17 MO1 output delay time 
Factory setting 0.0s
06-18
Relay RA-RB-RC output delay time

Factory setting 0.0s
06-19 Reserved
Factory setting
06-20 Reserved
Factory setting
06-21 DFM(M) output delay time

Factory setting 0.0s
Setting range 0.0s
～
3600.0s
Set the delay time for the output terminal Terminal to change from the state to the actual output.