SATO CT4-LX, Operator'S Manual, Page: 407 / 564

407
List of Initial Values
[Printing] Menu
The initial value refers to the setting value of the product when it was shipped from the factory. If you
reset the product, the setting values of the product will change back to the factory default values. The
table below shows the initial value of each setting item and type of reset that changes the value back
to the initial value.
• Normally, it is not necessary to perform the initialization. Doing an initialization removes
all the product's settings that the customer changed.
Setting Item Initial Value User Reset/
Factory Reset
[Media Type] Label Yes
[Label Length]
203 dpi
3200 dots
305 dpi
4800 dots
Yes
[Label Width]
203 dpi
832 dots
305 dpi
1248 dots
Yes
[Auto Measure] Disabled Yes
[Printing Mode] Use Ribbon Yes
[Ribbon Near End] Enabled Yes
[Speed] 4 ips Yes
[Sensor Type]
If [Print Mode] is set to
[Dispenser], [Tear-Off],
[Continuous], [Cutter], [Cut
& Print] or [Partial cutter]
Gap
If [Print Mode] is set
to [Linerless cutter] or
[Linerless tearoff]
None
Yes
[Auto-mode] Enabled Yes