SATO CT4-LX, Operator'S Manual, Page: 178 / 564

[Advanced]
178
Set the value '+' to move the offset position in the direction opposite to the feed direction and '-' to
move in the feed direction.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) -30 to +30 dots
305 dpi (1 dot = 0.083 mm (0.0033")) -45 to +45 dots
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
• The changes to this setting are linked and are changed with each of the test print
settings in the [Tools] > [Test Print] menu.
[Pitch]
By adjusting the print position, you can set the print start position to adjust the vertical print position.
Set the value '+' to move print position in the direction opposite to the feed direction and '-' to move in
the feed direction.
(1) Feed direction
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) -30 to +30 dots
305 dpi (1 dot = 0.083 mm (0.0033")) -45 to +45 dots