Ruijie RG-S29 Series, Command Reference Manual

Page: 617 / 1510

Command Reference Network Connectivity Test Tool Commands
Related
Command
s
Command Description
N/A N/A
Platform
Descriptio
n
N/A
10.3 ping ipv6
Use this command to test the connectivity of a network to locate the network connectivity problem. The
command format is as follows:
ping [ ipv6 ] [ ip-address [ length length ] [ ntimes times ] [ timeout seconds ] [ data data ] [ source source ]
[ detail ] [ interval millisecond ] [ out-interface interface [ next-hop next-hop ] ] ]
Parameter
Descriptio
n
Parameter Description
ip-address Specifies an IPv6 address.
length
Specifies the length of the packet to be sent (range: 36-18024, default:
100).
times Specifies the number of packets to be sent (range:1-4294967295).
seconds Specifies the timeout time (range: 1-10 seconds).
data Specifies the data to fill in.
source
Specifies the source IPv6 address or the source interface. The
loopback interface address (for example: 127.0.0.1) is not allowed to
be the source address.
detail
Sets whether to contain details in the echoed message. By default,
only
“!” and “.” are displayed.
interface Specifies the outbound interface
next-hop Specifies the next hop IPv6 address
millisecond Specifies the ping interval, in the range from 10 to 300000
milliseconds. Default: 100 milliseconds.
Defaults Five packets with 100Byte in length are sent to the specified IP address within specified time 2 seconds by
default
Command
Mode
Privileged EXEC mode.
Usage If the device can be pinged, the response information is displayed, and the statistics is listed at the end. If the