Ruijie RG-S29 Series, Command Reference Manual

Page: 262 / 1510

Command Reference Interface Commands
1.16 medium-type
Use this command to specify the medium type for an interface. Use the no form of this command to
restore the default setting.
medium-type { auto-select [ prefer [ fiber | copper ] ] | fiber | copper }
no medium-type
Parameter
Description
Parameter Description
fiber
Optical interface.
prefer [ fiber | copper ] The preferred medium type for the interface is selected.
auto-select Auto-selects the medium type for the interface.
copper Copper interface.
Defaults The default is copper .
Command
Mode
Interface configuration (physical interface, except for AP and SVI)
Usage Guide
Select either fiber or copper as the medium type of a port when both medium types are available.
Once the medium type is selected, all interface attributes, including the status, duplex mode, and
speed, are configured for the interface of the selected medium type. If the interface type is changed,
the attributes of the new interface type are the default attributes. You can reconfigure these attributes
as required.
If you enable automatic selection of the medium type, the device uses the current medium if only one
medium is available. If both media are available, the device uses the preferred medium as configured.
By default, the preferred medium is copper. You can run the medium-type auto-select prefer fiber
command to configure fiber as the preferred media. In automatic medium selection mode, the
interface adopts the default settings of attributes, such as the speed, duplex mode, and flow control
mode.
Configuration
Examples
The following example specifies the medium type for interface gigabitethernet 1/1.
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config-if)# medium-type copeer
Related
Commands
Command Description
show interfaces Displays the interface information.
Platform
Description