Ruijie RG-S29 Series, Command Reference Manual

Page: 728 / 1510

Command Reference OSPFv2 Commands
Configuration
Examples
The following example configures the priority offastethernet 0/1 as 0.
Switch(config)#interface fastethernet 0/1
Ruijie(config-if-FastEthernet 0/1)# ipospfpriority 0
Related
Commands
Command Description
ip ospf network Configures the network type of the interface.
Platform
Description
N/A
2.34 ip ospf retransmit-interval
Use this command to define the interval for sending the link state update (LSU) packet on the
interface in interface configuration mode. Use the no form of this command to restore the default
setting.
ip ospf retransmit-interval seconds
ip ospf retransmit-interval
Parameter
Description
Parameter Description
seconds
Interval for sending the LSU packets in seconds. The range is from 1
to 65535. This interval must be greater than the round trip delay of
packets between two neighbors.
Defaults The default is 5.
Command
Mode Interface configuration mode
Usage Guide After the device sends an LSU packet, the LSU packet stays in the transmission buffer queue. If no
confirmation from the neighbor is obtained in the interval defined with the ip ospf retransmit-interval
command, the LSU will be sent once again.
In serial lines or virtual links, the retransmission interval shall be slightly larger. The LSU packet
retransmission interval of virtual links is defined with the area virtual-link command followed with the
keyword retransmit-interval.
Configuration
Examples
The following example configures the LSU packet retransmission interval on fastEthernet 0/1 as 10
seconds.
Ruijie(config)# interface fastEthernet 0/1
Ruijie(config-if-FastEthernet 0/1)# ip ospf retransmit-interval 10
Related Command Description