Ruijie RG-S29 Series, Command Reference Manual

Page: 310 / 1510

Command Reference Aggregate Port Commands
Parameter
Description
Parameter Description
port-group-number Member group ID of an aggregate port, the interface number of the
aggregate port.
key-number Member group ID of an LACP aggregate port, the interface number of
the LACP aggregate port.
active
Places a port into an active negotiating state, in which the port initiates
negotiations with remote ports by sending LACP packets.
passive
Places a port into a passive negotiating state, in which the port responds
to LACP packets it receives but does not initiate LACP negotiation.
Defaults By default, the physical port does not belong to any aggregate port.
Command
Mode
Interface configuration mode.
Usage Guide
All the members of an aggregate port belong to a VLAN or configured to be trunk ports. The ports
belonging to different native VLANs cannot form an aggregate port.
Configuration
Examples
The following example specifies the Ethernet interface 1/3 as a member of the static AP 3.
Ruijie(config)# interface gigabitethernet 1/3
Ruijie(config-if-GigabitEthernet 1/3)# port-group 3
The following example specifies the Ethernet interface 2/3 as a member of the LACP AP4 and set the
aggregation mode to active.
Ruijie(config)# interface gigabitethernet 2/3
Ruijie(config-if-GigabitEthernet 2/3)# port-group 4 mode active
Related
Commands
Command Description
N/A N/A
Platform
Description
N/A
3.9 show aggregateport
Use this command to display the aggregate port configuration.
show aggregateport { [ aggregate-port-number ] summary | load-balance }
Parameter
Description
Parameter Description
aggregate-port-number Number of the aggregate port.
load-balance Displays the load-balance algorithm on the aggregate port.
summary Displays the summary of the aggregate port.