Ruijie RG-S29 Series, Command Reference Manual

Page: 464 / 1510

Command Reference ERPS Commands
Ruijie(config)# interface fastEthernet 0/2
Ruijie(config-if)# switchport mode trunk
Ruijie(config-if)# exit
# Enter the ERPS configuration mode.
Ruijie(config)# erps raps-vlan 4093
# Add the ports that participate in the ERPS protocol computing to the Ethernet ring.
Ruijie(config-erps4093)# ring-port west fastEthernet 0/1 east fastEthernet
0/2
# Enable the ERPS function for the specified ring.
Ruijie(config-erps4093)#state enable
# Enable the global ERPS function.
Ruijie(config-erps4093)# exit
Ruijie(config)# erps enable
Related
Commands
Command Description
erps enable Enable the global ERPS protocol.
Platform
Description
N/A
13.10 sub-ring tc-propagation
Use this command to specify the devices corresponding to the crossing node on the crossing ring
whether to send out the notification when the subring topology changes.
sub-ring tc_propagation enable
no sub-ring tc_propagation
Parameter
Description
Parameter Description
N/A N/A
Defaults By default, the topology changing notification is not sent.
Command
Mode
EPRS configuration mode.
Usage Guide This command is just needed to be configured on the crossing nodes on the crossing ring.
Configuration The following example is configured when the subring topology changes.