Riso V8000 Series, Technical Manual

Page: 77 / 362

[4 - 23]
CHAPTER 4. FIRST PAPER FEED SECTION
5. Position of Multiple Paper Feed Switch
1. Activate test mode No. 416, with the stripper unit attached to the main body, push down the
Stripper pad slowly with a finger. After pushing them down about 0.8mm to 1.2mm, make sure
that the Multiple Paper Feed switch is pressed and clicks(Fig. a)
2. If other than the specified value, remove the stripper unit.
3. Turn the adjusting screw to make adjustment.
• Viewing the adjusting screw from below, turning it counterclockwise causes the Stack Paper
Feed switch to approach the actuator plate, and turning it clockwise causes it to go away.
• One turn of the adjusting screw makes a change of about 0.5 mm.
4. Finally, apply a screw locking agent to the adjusting screw(Fig. c) and attach to the main body.
Fig. c
Fig. a
Fig. b
0.8mm
to
1.2mm
ON/OFF
Further
< Viewed from bottom >
Closer
Adjusting
Screw
Multiple Paper Feed Switch
Apply locking agent
Adjusting Screw
S0433
S0434