Riso V8000 Series, Technical Manual

Page: 283 / 362

[16 - 20]
CHAPTER 16. PANEL MESSAGES
DETAILED LIST OF PANEL MESSAGES
Jam errors (A--)
Error type A01 [Master feed error]
Panel display
A01-***
Mas ter Mis-Feed
Rewind Master Roll and Reset Master in Place
Res et method Open the mas ter making unit and rem ove the master. (Mas ter detection s ens or: OFF)
Error point Error conditions
227
Mas ter pos itioning sensor does not switch OFF even when the master is reversed for 1 s
when the pos itioning sensor is ON at the s tart of master positioning.
228
Mas ter pos itioning sensor does not go ON even when the m aster is fed for 2 s when the
positioning sens or is OFF at the start of m aster pos itioning.
229 Mas ter pos itioning sensor was OFF during standby.
285 Dis played following A02 1st master loading error].
286 Dis played following A03 1st print drum cutting error].
287 Dis played following A19 2nd master loading error].
288 Dis played following A33 2nd print drum cutting error].
Error type A02 [1st master loading error]
Panel display
A02-***
Mas ter Jam
Pull Out Print Drum 1 and Rem ove Master
Res et method
Pull out 1st print drum. (The 1st print drum set s ensor switches OFF, and the 1st print drum
connection s ignal switches OFF.)
Error point Error conditions
231 Mas ter loading s ensor does not go ON during master loading.
Error type A03 [1st print drum cutting error]
Panel display
A03-***
Mas ter was Not Loaded on Print Drum 1 Correctly
Pull Out Print Drum 1 and Rem ove Master
Res et method
Pull out 1st print drum. (1s t print drum set sensor s witches OFF and 1st print drum
connection s ignal switches OFF.)
Error point Error conditions
236
Mas ter pos itioning sensor does not switch OFF even when the print drum rotates 20° after
cutting.
Error type A04 [1st master disposal error]
Panel display
A04-***
Mas ter Disposal Error
Pull Out Print Drum 1 and Rem ove Master
Res et method
Pull out 1st print drum. (1s t print drum set sensor s witches OFF and 1st print drum
connection s ignal switches OFF.)
Error point Error conditions
331
Mas ter dis pos al jam s ens or does not go ON when disposal is complete (after the mas ter
disposal m otor stops ).
332
Mas ter dis pos al jam s ens or does not switch OFF when master com pres sion ends (after the
fourth compres sion).