Riso V8000 Series, Technical Manual

Page: 227 / 362

[13 - 9]
CHAPTER 13. AF SCANNING SECTION
P1314
3. Removing the Original Stripper Roller
(1) Remove the original pickup roller ass’y. (Refer to pages 6 and 7)
(2) Remove K holder C, the parallel pin, and the original pickup roller. (Refer to previous page)
(3) Detach the lock ring from the rear of the original stripper roller, and slide the original stripper roller in
the direction of the arrow mark on the photograph below.
(4) Remove the E-ring, and slide the K-holder F frame in the direction of the arrow mark. Then remove
the parallel pin from the shaft and remove the K-holder F frame.
(4) Remove the original stripper roller.
[Precautions on Reassembly]
•
When engaging the parallel pin with the K-holder F frame, insert it into the shallower groove on the
K-holder F frame.
•
Note the direction of the original stripper roller. It must be inserted with the gear end at the front.
< FRONT >
< REAR >
E-ring
Lock ring Original stripper roller K-holder F frame
K-holder F frame
Parallel pin
Joining area between “K-holder F” and “Parallel pin”
P1315