Riso V8000 Series, Technical Manual

Page: 292 / 362

[16 - 29]
CHAPTER 16. PANEL MESSAGES
DETAILED LIST OF PANEL MESSAGES
Error type D18 [2nd ink cartridge not set]
Panel dis play
D18-***
Install Ink Cartridge in Print Drum 2
Res et method Install the ink cartridge. (2nd ink cartridge s et SW: ON)
Error point Error conditions
579 2nd ink cartridge s et SW OFF.(This is dis played only when the test-mode No.599=”0”)
Error type D19 [Incorrect 2nd ink cartridge]
Panel dis play
D19-***
Wrong-Type Ink Cartridge Ins talled in Print Drum 2
Res et method Replace with the correct ink cartridge.
Error point Error conditions
582
Ink cartridge value detected by the sensor dos e not match the s et value.
(This is dis played only when the test-mode No.599=”0”)
Error type D20 [2nd Mas ter dis pos al box not set]
Panel dis play
D20-***
Set Mas ter Disposal Box 2 in Place
Res et method Set 2nd master disposal box. (2nd m as ter dis pos al box safety SW: ON)
Error point Error conditions
346 Mas ter dis pos al box s afety SW was OFF in standby mode.
347 Mas ter dis pos al box s afety SW was OFF during operations.
Error type D22 [D to P 1st print drum removal indication]
Panel dis play
D22-***
Pull Out Print Drum 1
Res et method
Pull out 1st print drum . (1s t print drum set sensor OFF, 1st print drum connection signal
OFF)
Error point Error conditions
585 The user must remove 1st print drum.
Error type D23 [D to P 2nd print drum removal indication]
Panel dis play
D23-***
Pull Out Print Drum 2
Res et method
Pull out 2nd print drum . (2nd print drum set sensor OFF; 2nd print drum connection signal
OFF)
Error point Error conditions
585 The user must remove 2nd print drum.
Error type D24 [1st print drum status error]
Panel dis play
D24-***
!! Print Drum 1 is Not in Correct Position !!
Check the Position of Print Drum 1
Res et method
Pull out 1st print drum . (1s t print drum set sensor OFF; 1st print drum connection signal
OFF)
Error point Error conditions
586 The inserted print drum was unlocked during idling.
587 Print drum inserted with position B lock released.(Drum lock position s ens or was OFF)
615 Horizontal centering sensor dose not go ON within 10s when connecting the drive.