Riso V8000 Series, Technical Manual

Page: 273 / 362

[16 - 10]
CHAPTER 16. PANEL MESSAGES
DETAILED LIST OF PANEL MESSAGES
Error type T17 [Solenoid counter not connected]
Res et method Connect the solenoid counter (Connection s ignal ON).
Error point Error conditions
004 Solenoid counter connection signal was OFF.
Error type T18 [Main pulse motor lock]
Res et method To be reset by Technician only
Error point Error conditions
522
On print drum No.1, the pos ition-B lock confirm ation sensor is OFF again at the finis h of B-
positioning retry after the first B positioning m ovem ent which ended up with the pos ition-B
lock confirm ation sensor OFF after the completion of the m ovem ent.
523
On print drum No.2, the pos ition-B lock confirm ation sensor is OFF again at the finis h of B-
positioning retry after the first B positioning m ovem ent which ended up with the pos ition-B
lock confirm ation sensor OFF after the completion of the m ovem ent.
525 Time out
526
Main puls e m otor is m onitored every 500 ms while operating, and m ain motor encoder count
is les s than 10 puls es between checks (under 0.35 rpm at design s etting).
527
Main encoder pulse count to pos ition A sens or exceeds the range of specifications when the
main pulse motor is operating.
528 1s t clamp (slide) unit is not at the reset position.
589 2nd clamp (slide) unit is not at the reset position.
590
1s t print drum set sensor is ON, 1st print drum connection s ignal is ON, and 1st print drum
lock position s ens or is OFF when the main pulse motor starts or is operating.
591
2nd print drum set sensor is ON, 2nd print drum connection signal is ON, and 2nd print
drum lock pos ition sensor is OFF when the main puls e m otor s tarts or is operating.
Error type T19 [Thermal press ure motor lock]
Res et method
Press the [OK] key or the Reset button
→
recovery operation (HP res etting), or switch on
power once again.
Error point Error conditions
211
TPH pressure release sensor does not s witch from ON
→
OFF within 4 s during the TPH
press ure release operation after the TPH press ure releas e s ens or goes ON.
212
TPH pressure release sensor does not s witch from OFF
→
ON within 4 s during the TPH
press ure release operation after the TPH press ure releas e s ens or s witches OFF.
213
TPH pressure release sensor does not s witch from OFF
→
ON within 4 s during the TPH
press urizing operation after the TPH pres sure release sensor goes ON.
214
TPH pressure release sensor does not s witch from ON
→
OFF within 4 s during the TPH
press urizing operation after the TPH pres sure release sensor switches OFF.
Panel display
T19-***
!!System Error!!
Press Reset Key.
If Recovery has Failed, Call Service
Panel display
T17-***
!!System Error!!
Press Reset Key.
If Recovery has Failed, Call Service
Panel display
T18-***
!!System Error!!
Press Reset Key.
If Recovery has Failed, Call Service