Riso V8000 Series, Technical Manual

Page: 301 / 362

[17 - 2]
CHAPTER 17. TEST MODE
PROCEDURES
1. Procedures
1) Start-up Procedure
Switch on power while simultaneously pressing the “
←
” and “
→
” print positioning keys on the panel. This
initiates test mode in standby mode.
2) Operating Procedure
Test mode numbers can be entered (selected) via “Key entry” or “Menu selection.”
a) Key entry procedure
(1) In standby mode, enter the number of the test mode to be run using the numeric keys. If you
make a mistake during entry, you can perform entry once again by pressing the “C” key.
(2) Press the “Start” key to initiate Test mode operations.
(3) Press the “Stop” or “Start” key to end Test mode and return to standby or operation standby
modes.
* After setting data, press the “Start” key to confirm the modified data and return to standby mode.
Press the “Stop” key to cancel settings before returning to standby mode.
b) Menu selection method
(1) While in standby mode, select the unit containing the test item to be run from the Test mode
menu.
• Press the unit name on the LCD screen. (Unit name is highlighted.)
•
The Test mode sub-menu appears.
(2) Select the test item to be run from the Test mode sub-menu.
• Press the test item on the LCD screen. (Test item is highlighted.)
(3) Press the “Start” key to initiate Test mode operations.
(4) Press the “Stop” or “Start” key to end the Test mode operation and return to standby mode or
operation standby mode.
* After setting data, press the “Start” key to confirm the modified data and return to standby mode.
Press the “Stop” key to cancel the settings before returning to standby mode.
3) Ending procedure
To exit the Test mode, press the “Reset” key for at least 1 second during test mode standby mode or test
mode operation standby mode.