Riso V8000 Series, Technical Manual

Page: 25 / 362

[1 - 14]
CHAPTER 1. MAINTENANCE
Scanner unit securing screw
Blind seal
15. Unscrew the Scanner unit securing screw located
under the Scanner table. Then remove the screw
from the unit sliding it to the right-hand.
16. Cover the hole, from which the Scanner unit
securing screw was removed, with the Blind seal.
(To affix the seal easily, it is recommended to make
a tab beforehand by folding its edge.)
17. Start up the test mode of the printer and activate
the “Scanner release action” (Test mode code
#155).
18. Lock the casters.
19. Measure the difference of levels between the front
and rear frame of the printer using the specified
jig. For the description about the jig and the
operation procedure, refer to the technical manual.
20. Insert the Adjustment feet under the front door to
fit the caster bases as illustrated.
21. Turn the lower nuts on the Adjustment feet
clockwise until the feet reach the floor.
22. Using the jig, adjust the levels of the Adjustment
feet by turning the lower nuts until both ends of
the printer are leveled.
23. Lock the Adjustment feet by tightening the center
nuts.
24. Stick the Instruction label on the illustrated part of
the paper feeding area.
Adjustment Foot
Center nut :
Locks the Adjustment foot
Lower nut : Adjusts the level of the printer
Instruction label
4