Riso V8000 Series, Technical Manual

Page: 278 / 362

[16 - 15]
CHAPTER 16. PANEL MESSAGES
DETAILED LIST OF PANEL MESSAGES
Error type T37 [MCTL PCB no battery]
Reset method Replace battery.
Error point Error conditions
010 No MCTL PCB backup battery. (The voltage of battery is under 2.3V)
Error type T38 [1s t clamp opening and clos ing motor lock]
Panel display
T38-***
!!System Error!!
Call Service
Reset method To be reset by Technician only
Error point Error conditions
542 0 angular s ens or does not go ON within 3s when opening the end clam p.
544 180 angular sensor does not go ON within 3s when opening the top clam p.
546
Clam p plate loading position s ensor does not go ON within 1.5s when half-clos ing the top
clamp.
548 0 angular s ens or does not go ON within 1.5s when clos ing the top clam p.
550 Clam p plate hom e pos ition sensor does not go ON within 1.5s when half-clos ing the end clam p.
552 180 angular sensor does not go ON within 1.5s when clos ing the end clam p.
554 Overload current detection
555
Clamp plate home pos ition sensor is ON at the start of the open and clos e returning operation
and clam p plate hom e pos ition sensor dose not go OFF within 3s during the rotation of the m otor
toward 180 angular.
556
Clam p plate hom e position s ens or dose not s witch from OFF to ON within 3s during the rotation
of the motor toward 0 angular when the open and close returning.
557
Clam p plate hom e pos ition sensor dose not switch from ON to OFF within 3s during the rotation
of the motor toward 180 angular after the clam p plate hom e position s ens or s witching from ON
to OFF when the open and clos e returning.
Error type T39 [1s t disposal plate motor lock]
Reset method Press the [OK] key or the Res et button
→
Recovery operation (HP resetting).
Error point Error conditions
311 Dis posal plate hom e sensor does not go ON within 3 s when the disposal plate returns.
313
Dis posal plate hom e sensor does not switch from ON to OFF within 0.5 s after the disposal plate
blaking goes ON.
314
Dis posal plate limit sensor does not go ON within 3 s when the dis pos al plate performs
compres sion.
315
Overload current was detected when the disposal plate motor operates. (It is not monitored
between 300ms ec after motor ON)
316
Both the dis pos al plate limit sensor and dispos al plate home s ens or were ON at the start of the
operation.
Panel display
T39-***
!!System Error!!
Press Res et Key.
If Recovery has Failed, Call Service
Panel display
T37-***
!!System Error!!
Press Res et Key.
If Recovery has Failed, Call Service