Riso V8000 Series, Technical Manual

Page: 285 / 362

[16 - 22]
CHAPTER 16. PANEL MESSAGES
DETAILED LIST OF PANEL MESSAGES
Error type A21 [2nd m aster present in master disposal section]
Panel display
A21-***
Mas ter Jamm ed in Disposal Unit
Pull Out Print Drum 2 and Rem ove Master
Res et method
Pull out 2nd print drum. (2nd print drum set sens or s witches OFF and 2nd print drum
connection s ignal switches OFF.)
Error point Error conditions
336 Mas ter dis pos al jam s ens or was ON at the start of m as ter making.
Error type A23 [2nd print drum unlocked]
Panel display
A23-***
Print Drum 2 has been Unlocked
To Lock it Again, Pull it Out and Set it Back in Place
Res et method
Pull out the 2nd print drum. (2nd print drum set sensor switches OFF and 2nd print drum
connection s ignal switches OFF.)
Error point Error conditions
561 Print drum lock was released for drum removal.
Error type A24 [AF original reset]
Panel display
A24-***
Place Originals in AF Again
Res et method Res et the original in the AF.
Error point Error conditions
116
Error type A29 [1st print drum clamp plate status error]
Panel display
A29-***
Pull Out Print Drum 1 and Check Clamp Plate Position
Res et method
Pull out 1st Print Drum. (1s t Print Drum set s ens or switches OFF and 1st Print Drum
connection s ignal switches OFF)
Error point Error conditions
564 Angular safety s ens or was ON when the end clamp was opened.
Error type A30 [2nd print drum clamp plate status error]
Panel display
A30-***
Pull Out Print Drum 2 and Check Clamp Plate Position
Res et method
Pull out print 2nd print drum . (2nd print drum set sens or s witches OFF and print 2nd print
drum connection signal s witches OFF)
Error point Error conditions
564 Angular safety s ens or was ON when the end clamp was opened.
Error type A31 [1st print drum reset]
Panel display
A31-***
Set Print Drum 1 in Place Again
Res et method
The 1st print drum set s ens or detects the 1s t print drum. (The 1st print drum set s ensor, the
1s t print drum connection signal, and the 1st print drum lock position s ens or all go ON.)
Error point Error conditions
567
The 1st print drum lock position s ens or dos e not go ON within 2 s after the 1s t print drum
connection s ignal and the 1st print drum set s ens or goes ON