Raven OmniSeed Viper Pro, Calibration & Operation Manual

Page: 141 / 308

6
Manual No. 016-3001-015 Rev. C 129
Viper Pro Guidance
Setting the Last Pass Pattern
If Swath Guidance is enabled, the Viper Pro will automatically display the ‘Guide’ tab when a job is opened.
The last pass pattern provides guidance based upon the nearest covered area so the operator does not need
to set points or record a swath path. To begin Last Pass guidance, begin applying product. Once the first swath
path is completed, Viper will detect the nearest area previously covered and use the programmed overall width
to determine the next guidance path.
Note:
Last Pass Guidance is based on the nearest covered area so the booms must be on in order to
utilize this guidance pattern.
Turn Around Lock
The Last Pass pattern uses the nearest, previously applied area, or last pass, to determine the guidance for
the next swath. If headlands areas are present and the Last Pass mode is active, the Viper Pro may display a
guidance line along the headlands area instead of the next swath.
Touch the icon to toggle the turn around lock feature on to provide guidance back along the last swath and
ignore the headlands area. Touch the icon again to toggle the turn around lock feature off to allow guidance
along the headlands area.
Note:
If an optional SmarTrax system is installed with the Viper Pro, a reverse sense icon may
display in the map area during operation. Refer to the SmarTrax Operation Manual for
more information about operating the SmarTrax system on the Viper Pro field computer.
Turn Around
Lock
Lock Enabled Lock Disabled