Raven OmniSeed Viper Pro, Calibration & Operation Manual

Page: 111 / 308

5
Manual No. 016-3001-015 Rev. C 99
Using the OmniSeed Viper Pro System
Prescription Rate Conversions and Default Rates
1.
When product setup is complete for each enabled product, the Rate Conversion screen will be displayed if
any prescription maps have been assigned to products.
Rate Conversions may be used to calibrate prescription maps for the application. Enter a value of ‘2’ to
double the prescription rates on the selected prescription map or a value of “0.8” to apply 80% of the
prescribed rate.
The Rate Conversions may also be used to convert a prescription map from liters or ounces to gallons, or
gallons to ounces or liters. Touch the
Common Factors button to view some common rate conversion
values.
Note:
The Rate Conversion value must be greater than zero. In most applications, the conversion factor
will be left at the default setting of 1.0.
2.
Enter a conversion factor for each product that will be applied according to a prescription map and touch
Next . Viper displays the Rx Map Default Value screen.
3.
Enter a standard rate of application for the channel when no prescription information is available. The
default rate only affects areas where prescription rate information has not been entered.
Note:
Zero rate zones will not be affected by the default rate setting.
4.
When the default rates values are set for each product, touch OK to complete the job set up process and
begin product application.