17 MARGIN
78 Planmeca Chairside CAD/CAM solution
User’s manual
4. Click on the margin. A dot appears as the starting point.
5. Draw the margin in the middle of the green high contour
indication.
To draw the margin using the Trace tool you may either:
• Click along the margin in small increments. The system
creates straight lines between each click.
or
• Draw a continuous line by holding down the left mouse
button. To stop release the mouse at any time. This
requires a steady drawing hand with the mouse and is not
recommended for beginners.
If desired, you can switch between clicks and drawing of
continuous lines.
6. Finish the margin by clicking on the starting point.
The system automatically changes the trace line into a
margin line.
7. To delete the margin and start over, click the Trace, or
Lasso button.
Lasso tool
The Lasso tool is recommended for partial restorations
and supragingival margins with a sharp edge.
1. Click the Lasso button.
2. Click along the margin at large intervals. The system
creates a line along the edge between each click.
NOTE
If Lasso is having trouble finding the margin, you can
change the ICE Margin Mode to Texture Only.
3. The starting point and the most recent point clicked
appear as blue dots.
4. Click to accept the previewed segment.
5. To finish the margin click the starting blue dot.
To delete the margin and start over, click the Trace, or
Lasso button.
