29 CLEANING / PREVENTIVE MAINTENANCE
152 Planmeca Chairside CAD/CAM solution
User’s manual
11.Insert the collet into the spindle.
12.Use the wrench to hold the spindle housing in place and
use the collet tool to tighten the collet. Be sure to use your
fingertips to turn the tool to avoid using too much torque.
13.Insert the Nozzle Cleaning Brush in the small holes on the
spindle cap at an angle. This will push any ceramic build-
up out of the hole.
14.Clean the cap and the gasket with water.
15.Replace the spindle cap with the gasket.
16.Align the spindle cap and gasket using two of the screws.
This ensures the gasket does not slip out of position while
the pieces are being screwed into place.
17.Tighten the screws with the hex wrench side of the collet
tool. Use your fingertips to turn the tool to avoid using too
much torque.
18.Close lid when finished.
The tools remain in the tool changer until the next
restoration is selected to mill.
