Parker PAC, Installation Manual, Page: 41 / 197

Configuring the Network and System Settings
Upon powering the system for the first time, use the PAC Configuration Tool to configure the initial system
parameters. After commissioning the machine, these parameters need to be changed.
To run the PAC Configuration Tool located in the PAC Controller, perform the following steps:
1.
2. As shipped from the factory, the PAC Controller IP Address is defaulted to 192.168.10.50. To avoid
network IP address conflicts, set the Network Settings on the laptop/PC to IP 192.168.10.51 and
Subnet Mask to 255.255.0.0 by following the procedure below.
a)
For Microsoft Windows 7, open the Network connections dialog box Network connections:
Start > Control Panel > Network and Sharing Center.
b)
.
c)
Right-
d)
Click Properties.
e)
Select Internet Protocol Version 4 (TCP/IPv4).
f)
Click Properties.
g)

Enter the following IP address that will not conflict with the Controller:
192.168.10.51.

Enter the following subnet mask: 255.255.0.0
h)
Close the individual dialog windows by clicking OK to exit the Network Configuration tool.
3. Open a Microsoft Windows Internet Explorer browser window (IE 8 or later).
4.
To communicate with the controller, type the following IP address in the browser address bar:
http://192.168.10.50:81
5. You should see the following:
Login Tab
This tab is used to log into the PAC Configuration Tool. Enter your Username and Password to gain
access to the configuration tool. The default username and password from the factory are Admin with the
password box empty (no password). If you do not know your username or password, please consult with
the Administrator of the PAC Controller.