Parker PAC, Installation Manual, Page: 30 / 197

INSTALLATION
30 Parker Automation Controller Installation Guide
PACIO Module Installation
Follow the instructions below to mount the PACIO Modules on the DIN rail (DIN EN 50022, 35 x 7.5 mm),
and attach them to the Controller.
To add modules to the PAC
1. About 1 cm to the right of the Controller, push the PACIO Module up against the mounting rail
from below, allowing the metal spring to snap in between the mounting rail and mounting area.
2. Push the Module against the mounting wall until it snaps into place.
3. Slide the module to the left until it engages with the E-Bus connector on the Controller.
4. Repeat steps 1 through 3 to add additional modules.
Note: To ensure smooth functionality of the PACIO modules, the PACIO modules must be arranged
based on their e-bus load. The modules with the biggest e-bus load are to be arranged
directly next to the PAC Controller. The modules with the smallest e-bus load should be the
furthest from the PAC.