Parker PAC, Installation Manual, Page: 20 / 197

INSTALLATION
20 Parker Automation Controller Installation Guide
Checking Your Shipment
Use the following steps to check your PAC shipment. Note that PACIO Modules may be shipped in
packaging that is separate from the PAC Controller.
Remove all items from the packaging.
Confirm that you have received each item listed in the table below.
Technical Assistance from
Parker Hannifin in the Troubleshooting chapter of this guide.
PAC Ship Kit
Part Name
Part Number
Parker Automation Controller PAC320-xxxxx-xx
SD Card 33-026611-01
DC Power Input Connector,
3-Pin with tension-clamp wire terminals
43-026582-01 (inserted in the PAC)
Parker Software License Agreement A4-04291-102
Getting Started Sheet 88-032477-01
Required Tools
Installing the PAC and PACIO Modules on the DIN rail requires no tools. However, a small flat blade
screwdriver (tip size 0.04mm x 2.5mm) is required for attaching the wiring to the PAC Controller and
PACIO Modules.
Installation Safety Requirements
The PAC meets the requirements of the European Low Voltage Directive (LVD) 2006/95/EC and the
Electromagnetic Compliance (EMC) directive 2004/108/EC, and Safety Requirements EN61010 when
installed according to the instructions provided in this chapter.
WARNING: To avoid injury or electrical shock, always remove power to the
PAC before connecting electrical devices (for example, PACIO
Modules).
WARNING: The PAC connects to other mechanical and electrical components
of your system. Be sure to test your system for safety under all
potential conditions. Failure to do so may result in serious
personal injury or damage to equipment.