Parker PAC, Installation Manual, Page: 170 / 197

COMMUNICATIONS MODULES
170 Parker Automation Controller Installation Guide
4 Network interfaces
5 Sliding latch
Number Feature Name Description
1 Sliding latch
Locks the Communication Module into the PAC. Used to remove and
insert the Module into the Controller.
2 Brackets
Affixes the Communication Module to the carrier board of the PAC. Also
provides an Earth ground connection for EMI shielding.
3 Connector Interfaces with the PAC
Installation
1.
First, remove power from the PAC Controller.
2.
Set the sliding latch located on the underside of
the Communication Module to the mounting
position. Pull the handle of the sliding latch half
way out of the module. Mounting position 1 is
reached when the latch is approximately at the
center position of the guiding rails.
3.
Insert the module approximately half way into
the cutout opening on the face of the Controller.
4.
Tilt the module slightly downwards and push it
further into the Controller.