iConnectAccess624W
26
Wide Area Network (WAN) Setup
Before the router will pass any data between the LAN and WAN interfaces, the WAN side
of the iConnectAccess624W must be configured. Depending on your ISP, you will need
some (or all) of the information outlined below before you can properly configure the
WAN.
The following table lists all DSL requirements:
DSL Requirement
Comment
VPI and VCI
The VPI (Virtual Path Identifier) and the VCI (Virtual
Channel Identifier) define the virtual path settings for the
ADSL connection between you and your ISP. By default,
these settings are pre-configured for 8/35 in your
iConnectAccess624W.
Training Mode
The default is MMODE, and this enables your
iConnectAccess624W to tune into the ADSL services in
Australia automatically. Do not change this parameter.
PPPoA / PPPoE Requirement
Username
Your username is required for authentication to your ISP.
Password
Your username is required for authentication to your ISP.
Static Type Requirement
DSL Fixed Internet IP Address
Subnet Mask
Default Gateway
Primary DNS IP Address
Connection Types
As multiple users can use the iConnectAccess624W, different profiles must be set up for
different connections. The iConnectAccess624W supports the following connection
types:
PPPoE;
PPPoA;
Bridged;
Static;
DHCP;
CLIP.
Your iConnectAccess624W can support up to 8 unique virtual connections. If you have
multiple virtual connections, you may need to utilize the static and dynamic routing
capabilities of the router to pass data correctly.
