iConnectAccess624W
34
step 12
Click Apply,
then
Tools. The following screen appears:
step 13
Click
System Commands, then Save All. Click OK to confirm the save
when the following appears:
The following table lists the Static Connection Setup screen fields and their definitions:
Field Description
NAT
Network Address Translation is a feature that enables you to use private IP
addresses on your PC or your LAN. This is set to Enabled by default for
standard operation.
Firewall
Select to enable firewalling on this connection. This is set to Enabled
by default
for standard operation.
LLC and VC are two different methods of encapsulating multiple sessions. This
is set to LLC by default.
LLC
With LLC encapsulation, a link control header is added to the Ethernet
packet that identifies the protocol type (Ethernet). This allows multiple
protocols to be transmitted over the ATM Virtual Circuit.
Encapsulation
VC
With VC Multiplexing, no link control header is needed as the ATM
Virtual Circuit is assumed to be carrying a single protocol
IP Address
This is the static IP that will be assigned to the WAN interface of the
iConnectAccess624W. This will be provided by your ISP.
Mask
A mask used to determine to which the subnet an IP address belongs. This is
the Subnet Mask that will be assigned to the WAN interface of the
iConnectAccess624W. This will be provided by your ISP.
Default Gateway
The default gateway is a host to which local computers send data that is
destined for a non-local machine. On the iConnectAccess624W, configure the
default gateway address here to reach all computers that are not on the same
local IP subnet.
DNS 1 – DNS 3
DNS service is used to translate a Domain Name into a corresponding IP
address. The DNS server name should be obtained from your ISP.
Mode
Routed or Bridged mode can be selected here.
VPI
The VPI (Virtual Path Identifier) defines the virtual path settings for the ADSL
