iConnectAccess624W
78
Static Routing
If the iConnectAccess624W is connected to more than one network, you may need to set
up a static route between them. A static route is a pre-defined pathway down which
network information must travel to reach a specific host or network.
To Enable Static Routing:
From any screen in the web interface,
step 1
Click the Advanced tab, then Static Routing. The following screen
appears:
step 2
From the Choose a connection drop-down list, select a connection type.
step 3
Enter the new destination IP for the remote LAN network or host to which
you wish to assign a static route in the New Destination IP field.
step 4
Enter a subnet mask in the Mask field.
step 5
Enter the IP address of the new device to connect with the remote network
or host in the Gateway field.
step 6
Enter a metric in the Metric field.
step 7
Click Apply, then Tools. The following appears:
step 8
Click
System Commands, then Save All. Click OK to confirm the save
when the following appears:
