Omron AC1-152000, User Manual, Page: 127 / 230

Hardware Arrangement
The coils and contacts in electromagnetic contacts and relays in an external circuit are sources of
noise. Do not install them close to the IPC. Locate them at least 100 mm away from the IPC.
Example of Arrangement in Panel
AC I/O
device
Terminal block
DC I/O
device
OMRON
product
Wire Layout for the Power Supply
Observe the following points when wiring the power supply system.
• Separate the IPC power supply from the I/O device power supply and install a noise filter near the
IPC power supply feed section.
• Use an isolating transformer to significantly reduce noise between the IPC and the ground. Install
the isolating transformer between the IPC power supply and the noise filter, and do not ground the
secondary coil of the transformer.
• Keep the wiring between the transformer and the IPC as short as possible, twist the wires well, and
keep the wiring separate from high-voltage and power lines.
Unit power supply for Omron product
I/O power supply for Omron product
Power Supply System Diagram
Power circuits
Power supply for general operations circuits
Outlet (for peripheral devices)
I/O power supply for Omron product
Noise
filter
5 Installation
5-15
IPC Application Controller User's Manual (I632)
5-3 Mount
5
5-3-7
Electrical Environment